First, clean up the scene
The construction site is cleared, and the garbage on the ground is cleaned up, including every corner. The ground is not clean, and there will be a feeling of “sandy” under the floor in the future.
Second, level the ground
Then level the ground, the level error cannot exceed 2mm, if it exceeds, find a way to level it. If the ground is uneven, the foot feel of the floor will be bad. Then it is to trim the edges and corners and other parts of the ground that are protruding or uneven.
Third, lay the moisture-proof layer
After the floor is cleaned, the moisture-proof layer is laid to prevent the floor from getting damp in the future. The moisture-proof layer should be flat and the joints should be close together.
Fourth, saw the floor
The next task is to officially start installing the floor, because the floor is to be installed in a staggered way. First, you must pre-lay the floor, divide part of the floor into two, and saw according to the size. In case of more sawing, the floor loss will be large.
Before sawing the floor, you can unpack all the floors and pick out the problematic or defective floors for sawing. This can effectively make full use of the locally problematic floors without excessive loss. Don’t take the floor and saw when you come up, it will increase the loss.
The place for sawing the floor must be on the balcony and other places where there are tiles for easy maintenance, otherwise the splashed wood ash will enter everywhere and it is difficult to clean.
Fifth, leave expansion joints
Because the floor has a certain expansion rate, it is necessary to reserve expansion joints at the part where it contacts the wall before paving to prevent the floor from bulging. The size of the expansion joint is generally related to the expansion coefficient of the floor.
Sixth, check whether the glue is qualified
The glue for bonding the floor should be specially designed for laminate flooring, and the pollution of this glue is relatively small. Don’t randomly choose non-floor adhesives on the market, it will increase the pollution source on the floor itself. Before you shop, see if the glue is used correctly.
Seventh, start laying the floor
The next step is to lay the floor. When laying, place a short piece next to a long piece, so that the cross-laid floor will be bitten and not easy to loosen. After the floor is put together, it must be tapped with tools.
Eighth, connect and install the anchor line
The next step is the convergence, which is usually covered by floor battens. But it is also filled with glass glue, depending on what you like.
2020-10-10