Glass partition wall practice

1. When making bathroom glass partitions, you must first lay floor tiles and wall tiles, and then customize the sanitary partition according to the actual size. Please note that the upper and lower walls of the wall may have errors. The glass partitions are customized according to the actual size. It is easy to install and use.
2. Before laying the floor tiles, remember to install the sewer pipe and then install the floor drain. Then install the door frame when installing the partition. The door frame can be used to block water. If there is no door frame, it is better to install a threshold stone. The threshold stone should be 1.5-2 cm above the ground, otherwise the shower water will not reach the wet and dry zone when the shower water flows out from the door. The purpose of it.
3. When installing the glass partition, you must remember not to use the sliding slide, because the water and dust in the slide are difficult to clean up, and after a long time, it will stink and affect the indoor air.
4. When choosing sanitary partition glass, everyone must be particular about it. Don’t choose jade sand glass for partitions. Jade sand glass will become transparent when it encounters water, which will cause a lot of inconvenience.
5. After the glass is installed, everyone should pay attention to it when using it. In order to extend the service life of the partition, it is best to wipe it clean with a dry cloth after taking a bath. Remember not to leave any water stains. If there is water stains, then you can use white vinegar to lightly spray on the glass surface, after a while, you can wipe it with a cloth.