The first step of wall-hung toilet installation: adjust the height of the water tank
Side-press type water tank: According to the thickness of the decorative layer Xcm, from the horizontal line in the white box diagram on the upper part of the bracket to the bottom of the adjustable foot is 100cm+Xcm. Top-pressing water tank: According to the thickness of the decorative layer Xcm, the adjustable foot from the top of the bracket to the bottom of the bracket is 82cm+Xcm. The bracket adjustment legs can only be adjusted to a maximum of 20 cm without special lengthening.
The second step of wall-mounted toilet installation: fixing screws
The installation of the water tank bracket is mainly fixed by 4 screws, two on the upper part of the bracket and two on the supporting feet; at the same time, all screws on the water tank bracket must be tightened. When installing, ensure that the surface of the water tank bracket is horizontal and the vertical surface is vertical.
The third step of wall-hung toilet installation: water supply pipe connection
The water tank inlet should be connected with the indoor water supply pipe (hard tube) and the water tank inlet angle valve. It is strictly forbidden to install the angle valve in the water tank outside the box body, so as to avoid the angle valve cannot be opened and closed during the cleaning and maintenance of the water tank. It is strictly forbidden to connect the water supply pipe and the angle valve of the water tank with a hose. The pressure of the pipeline and the quality of the hose may cause leakage. In case of leakage, the false wall must be damaged for repair.
The fourth step of wall-hung toilet installation: drainage pipe installation
If the concealed water tank is installed in the original pit, the short pipe connecting the water tank and the drainage pipe must be larger than φ90 to prevent blockage.
The fifth step of wall-mounted toilet installation: installation of protective device
All protective devices should be installed before false wall production and decoration layer installation. Install the screw protection hose, which is divided into two parts and sleeved at the front and rear ends of the screw to avoid blocking the screw holes when building false walls or installing decorative layers.
The sixth step of wall-hung toilet installation: false wall production
1. Light steel keel + moisture-proof gypsum board: The surface of the light steel keel and the water tank bracket must be flat. The water tank protection frame, flushing pipe, drain pipe and screw position shall be reserved on the gypsum board. The surface of the gypsum board must be close to the surface of the bracket and fixed. The water tank bracket is filled with bricks or concrete below the elbow of the toilet to avoid the decoration material breaking when the toilet is used because the gypsum board is not closely attached to the bracket.
The seventh step of wall-hung toilet installation: installation of the toilet
After the false wall is decorated, the tiles are already pasted. Paste the sound insulation pad on the decorative wall, measure and cut the pipe, and then install the toilet according to the position of the screw. The length of the screw exceeds the ceramic surface. Fix the toilet on the wall. When installing the wall-mounted toilet, pay attention to adjusting the horizontal position of the toilet. After the installation is completed, cut off the excess sound insulation pad, and you are done.
2020-10-10